TELEVISION CAMERA (for Front Passenger Side) REMOVAL


  1. REMOVE OUTER REAR VIEW MIRROR GLASS


    1. A01NF4BE01

      Push the upper part of the mirror surface and tilt it.

    2. Apply protective tape to the areas shown in the illustration.

    3. Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror.

      Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover
    4. A01NFMVE01

      Push the lower part of the mirror surface and tilt it.

    5. Apply protective tape to the areas shown in the illustration.

    6. Using a moulding remover, disengage the 2 claws at the upper part of the outer rear view mirror, and separate the outer rear view mirror glass.

      Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover
    7. A01NF0T

      Disconnect each connector and remove the outer rear view mirror glass.

  2. REMOVE SIDE TELEVISION CAMERA ASSEMBLY


    1. A01NHC8

      Remove the 4 screws.

    2. A01NG6F

      Disengage the 4 claws and disconnect the outer mirror cover with the side turn signal light assembly.

    3. A01NGUD

      Disconnect the connector and remove the outer mirror cover with the side turn signal light assembly.

    4. A01NDBC

      Disconnect the foot light bulb with the bulb socket as shown in the illustration.

    5. Insert a 0.9 mm (0.0354 in.) spark plug gap gauge or similar tool to the side of the claw engagement portion as shown in the illustration, tilt up the claw on the connector and disconnect the camera connector.

      A01NGGFE01
      Text in Illustration
      *1 Claw *2 Protrusion
      *3 Insert Position - -

      Note


      • Insert the gauge enough so that the claw becomes the same height as the protrusion of the connector housing. If the gauge is inserted too far, or if the notch on the claw is lifted directly using a screwdriver, the claw may be damaged.

      • When the claw on the connector is damaged, replace the luggage door opening switch assembly.

    6. Disengage the connector clamp.

    7. Disengage the claw and remove the foot light unit.

    8. A01NFIM

      Remove the 3 screws and side television camera assembly.