REAR VIEW MONITOR SYSTEM Inner Rear View Mirror Power Source Circuit

DESCRIPTION

This circuit detects the state of the power switch, and sends it to the inner rear view mirror assembly.

WIRING DIAGRAM

A01NEPJE02

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (BATTERY - INNER REAR VIEW MIRROR ASSEMBLY)


    1. A01NDXZE02
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Inner Rear View Mirror Assembly)

      Disconnect the T5 inner rear view mirror assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      T5-1 (IG) - T5-2 (E) Power switch on (IG) 11 to 14 V
      Power switch off Below 1 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here