REAR VIEW MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips

Use the following procedure to troubleshoot the rear view monitor system.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the power switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


      NEXT

  3. CUSTOMER PROBLEM ANALYSIS


    NEXT

  4. PROBLEM SYMPTOM CONFIRMATION

    Result
    Result Proceed to
    Symptom occurs A
    Symptom does not occur B

    B

    USE SIMULATION METHOD TO CHECK Click here

    A

  5. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

      B

      Go to step 7
      A

  6. BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW


    1. Terminals of ECU Click here


      NEXT

  7. ADJUST, REPAIR OR REPLACE


    NEXT

  8. CONFIRMATION TEST


    NEXT
    END