PARKING ASSIST MONITOR SYSTEM, Diagnostic DTC:C1613

DTC Code DTC Name
C1613 ACC Voltage is Low or High

DESCRIPTION

This DTC is stored if the parking assist ECU judges as a result of its self check that the voltage received by terminal ACC is not normal.

DTC No. DTC Detection Condition Trouble Area
C1613

  • ACC voltage is low

  • ACC voltage is high

  • Harness or connector

  • Parking assist ECU

WIRING DIAGRAM

A01NGWKE02

INSPECTION PROCEDURE

Note


  • When "System initializing" is displayed on the multi-display after the battery terminal disconnected, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

PROCEDURE


  1. CHECK DTC OUTPUT


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC C1613 is output A
      No DTC is output B

      Tech Tips

      If the parking assist ECU cannot read the stored information when it is activated, allowing the ECU to store the information again may return the system to normal.


    B

    USE SIMULATION METHOD TO CHECK Click here

    A

  2. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU ACC VOLTAGE)


    1. A01NEXPE03
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Parking Assist ECU)

      Disconnect the F54 connector from the parking assist ECU.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      F54-8 (ACC) - F54-3 (GND1) Power switch on (ACC) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE PARKING ASSIST ECU Click here