TELEPHONE ANTENNA CORD INSTALLATION


  1. INSTALL NO. 4 ANTENNA CORD SUB-ASSEMBLY


    1. A01NDGGE01
      Text in Illustration
      *1 Front

      Engage the 2 claws to connect the antenna cord connector.

    2. Engage the 2 clamps.

    3. A01NCXV

      Engage the 5 clamps to install the No. 4 antenna cord sub-assembly.

    4. Connect the connector.

  2. INSTALL NO. 5 ANTENNA CORD SUB-ASSEMBLY

    Tech Tips

    Double-sided tape and tape are not available as supply parts. If the tape still has enough adhesion to secure the roof headlining and antenna cord, reuse it. If the roof headlining has been replaced with a new one, or if the tape and/or the double-sided tape is no longer sticky, apply new tape following the procedure below.

    If the double-sided tape cannot be reused:


    1. Peel off the release paper from one side of new double-sided tape and apply the new double-sided tape to the position indicated in the illustration. Be careful not to touch the adhesive surface.

      Note

      Be sure to apply the double-sided tape carefully so that the tape will not be misaligned or come off.

    2. Peel off the release paper from the double-sided tape. Be careful not to touch the adhesive surface.

      A01NF21E01
      Area Dimension
      X 1.0 mm (0.0394 in.)
      Y 15.0 mm (0.591 in.)

    3. Align the vehicle front side marking (yellow) on the No. 5 antenna cord sub-assembly with the vehicle front side tab on the roof headlining, and wrap the tape over the antenna cord to install it. (A)

      Tech Tips

      If the tape cannot be reused, packing tape can be used as a substitute.

    4. Temporarily install the No. 5 antenna cord sub-assembly by placing it on the double-sided tape from the front of the vehicle to the point just before the extra cord storage area.

    5. Align the vehicle rear marking (yellow) on the No. 5 antenna cord sub-assembly with the tape attachment location (scribe line) of the roof headlining, and wrap the tape over the antenna cord to install it. (B)

      Tech Tips

      If the tape cannot be reused, packing tape can be used as a substitute.

    6. Temporarily install the No. 5 antenna cord sub-assembly by placing it on the double-sided tape from the rear of the vehicle to the point just before the extra cord storage area.

    7. Using double-sided tape, place any excess No. 5 antenna cord sub-assembly in the extra cord storage area to finish installing the antenna cord.

      Tech Tips

      Attach 3 pieces of double-sided tape to the extra cord storage area as shown in the illustration.

      A01NGNME01
      Area Dimension
      X 1.0 mm (0.0394 in.)
      Y 15.0 mm (0.591 in.)

  3. INSTALL ROOF HEADLINING ASSEMBLY

    Tech Tips

    Refer to the procedure from Install Roof Headlining Assembly Click here.