REMOTE TOUCH REMOVAL


  1. PRECAUTION

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. REMOVE REAR DECK FLOOR BOX


    1. A01NDSY

      Remove the 3 clips and the rear deck floor box.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A01NGN8

      Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.

  5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A01NGRU

      Move the shift lever to N.

    2. Pull the upper console panel sub-assembly in the direction indicated by the arrow to disengage the 4 claws and 4 clips.

    3. w/o Seat Heater System:


      1. Disconnect the connector from the console box hole cover.

    4. A01NDQX

      w/ Seat Heater System:


      1. Disengage the 4 claws.

      2. Disconnect the connector and remove the seat heater switch assembly.

    5. A01NEP7

      Pull the upper console panel sub-assembly in the direction indicated by the arrow to disengage the 3 claws and 3 clips.

    6. Disconnect each connector.

    7. Disengage the clamp and remove the upper console panel sub-assembly.

  6. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY


    1. A01NHQG

      Remove the 5 screws <F> and console cup holder box sub-assembly.

  7. REMOVE REMOTE TOUCH


    1. A01NDEW

      Disengage the 6 claws and remove the remote touch.