NAVIGATION SYSTEM (for DVD) Current Position Display does not Appear

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK NAVIGATION MODULE BOARD


    1. A01NF9R

      Display the "Map DVD" screen.

    2. Check if a disc is inserted into the MAP disc slot.


      1. Check if the map data version is displayed in the "Map Data" section.

        OK
        The map data version is displayed.

    NG

    INSERT MAP DISC IN MAP SIDE SLOT

    OK

  2. CHECK MAP DISC


    1. A01NEP6E12

      Check that the map disc is not deformed or cracked.

      OK
      No deformations or cracks on the map disc

    NG

    REPLACE MAP DISC

    OK

  3. CHECK CABIN


    1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

      Tech Tips


      • A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.

      • The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

      OK
      Condensation is not likely being produced and the temperature is not high or extremely low.

    NG

    CABIN TO APPROPRIATE TEMPERATURE

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here