NAVIGATION SYSTEM (for DVD) Map Display Incomplete

INSPECTION PROCEDURE

PROCEDURE

1. CHECK MAP DISC

   
   

   1. 

      Check that the map disc is not deformed or cracked.

      OK
      No deformations or cracks on the map disc

   
   

   NG

   REPLACE MAP DISC

   OK

2. CHECK MAP DISC

   
   

   1. 

      Check for dirt on the map disc surface.

      OK
      No dirt is on the map disc surface.

      Note

      Do not use a conventional record cleaner or anti-static preservative.

      Tech Tips

      If dirt on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

   
   

   NG

   MAP DISC

   OK

3. CHECK CABIN

   
   

   1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

      Tech Tips

      
      

      • A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.

      • The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

      OK
      Condensation is not likely being produced and the temperature is not high or extremely low.

   
   

   NG

   SET CABIN TO APPROPRIATE TEMPERATURE

   OK

4. CHECK NAVIGATION DISPLAY

   
   

   1. Check that displays other than the navigation display are complete.

      OK
      No other incomplete displays are found.

   
   

   NG

   REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY Click here

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here