NOISE FILTER INSTALLATION


  1. INSTALL RADIO SETTING CONDENSER


    1. A01NFOT

      Engage the claw to install a new terminal cover to wire harness.

    2. A01NENN

      Engage the 3 claws to install the new terminal cover with wire harness to a new condenser.

    3. A01NEO4

      Engage the clamp to temporarily install the new radio setting condenser with wire harness to the back door.

    4. Install the new radio setting condenser with the bolt.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

  2. INSTALL BACK DOOR TRIM PANEL ASSEMBLY


    1. A01NH51E01
      Text in Illustration
      *1 2-piece Type Clip

      Engage the 2 claws and 16 clips to install the back door trim panel assembly.

    2. Install the 2 screws.

  3. INSTALL BACK DOOR SERVICE HOLE COVER RH


    1. A01NCYF

      Engage the 5 claws to install the back door service hole cover RH.

  4. INSTALL BACK DOOR SERVICE HOLE COVER LH


    1. A01NH4X

      Engage the 5 claws to install the back door service hole cover LH.

  5. INSTALL BACK DOOR UPPER TRIM COVER RH


    1. A01NF17

      Engage the 2 claws to install the back door upper trim cover RH.

  6. INSTALL BACK DOOR UPPER TRIM COVER LH


    1. A01ND49

      Engage the 2 claws to install the back door upper trim cover LH.

  7. INSTALL NO. 2 ROOM LIGHT ASSEMBLY


    1. Connect the connector.

    2. A01NHOL

      Engage the claw to install the No. 2 room light assembly.

  8. INSTALL BACK DOOR LOCK COVER


    1. A01NDAS

      Engage the 4 claws to install the back door lock cover.

  9. INSTALL DOOR PULL HANDLE WITH SWITCH (w/ Power Back Door)


    1. Connect the connector.

    2. A01NH9U

      Engage the 6 claws to install the door pull handle with switch.

  10. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)


    1. A01NHXM

      Engage the 6 claws to install the back door finish cover RH.

  11. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)


    1. A01NHW1

      Engage the 4 claws to install the back door trim base.

  12. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)


    1. A01NFVY

      Engage the 6 claws to install the back door finish cover LH.

  13. INSTALL TONNEAU COVER SUB-ASSEMBLY