REMOVE DECK BOARD SUB-ASSEMBLY
Disengage the 3 fasteners as shown in the illustration.
for Compact Spare Tire:
Remove the 2 bolts and remove the deck board sub-assembly.
for Full Size Spare Tire:
Remove the 2 bolts and remove the deck board sub-assembly.
REMOVE NO. 4 REAR FLOOR BOARD (for Compact Spare Tire)
Disengage the 2 guides and remove the No. 4 rear floor board.
REMOVE NO. 4 REAR FLOOR BOARD (for Full Size Spare Tire)
Disengage the 2 guides and remove the No. 4 rear floor board.
REMOVE TONNEAU COVER ASSEMBLY
Remove the tonneau cover assembly.
REMOVE REAR DECK FLOOR BOX
Remove the 3 clips and the rear deck floor box.
REMOVE DECK SIDE TRIM BOX LH (for Compact Spare Tire)
Remove the 2 clips and the deck side trim box LH.
REMOVE DECK SIDE TRIM BOX LH (for Full Size Spare Tire)
Remove the 3 clips and the deck side trim box LH.
REMOVE FRONT DECK FLOOR BOX
Remove the clip and the front deck floor box.
REMOVE REAR SEAT ASSEMBLY LH
Tech Tips
Refer to the procedure up to Remove Rear Seat Assembly LH Click here.
REMOVE REAR DOOR SCUFF PLATE LH
Disengage the 6 claws, 3 clips and guide, and remove the rear door scuff plate LH.
REMOVE REAR FLOOR FINISH PLATE
Disengage the 2 claws, 6 clips and 2 guides, and remove the rear floor finish plate.
REMOVE REAR FLOOR FINISH SIDE PLATE LH
Remove the clip.
Disengage the claw and 2 clips.
Disengage the guide and remove the rear floor finish side plate LH.
REMOVE REAR SEAT SIDE COVER LH
Remove the 2 clips.
Disengage the 2 claws and 3 clips, and remove the rear seat side cover LH.
Tech Tips
A part of the clip remains on the vehicle side.
REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Remove the No. 1 luggage compartment trim hook as shown in the illustration.
REMOVE ROPE HOOK ASSEMBLY
| *1 | Protective Tape |
Using a screwdriver, disengage the 2 claws.
Tech Tips
Tape the screwdriver tip before use.
Remove the 2 bolts and the 2 rope hook assemblies.
REMOVE RECLINING REMOTE CONTROL BEZEL LH
Using moulding remover A, disengage the 2 bottom claws of the reclining remote control bezel LH.
Lift the reclining remote control bezel LH as shown by the arrow (1) in the illustration.
Turn the reclining remote control bezel LH as shown by the arrow (2) in the illustration, then disengage the 2 upper claws and remove the bezel.
REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Remove the 2 screws.
Remove the 4 clips.
Disengage the 5 claws and 2 clips.
Disconnect each connector and remove the deck trim side panel assembly LH.
REMOVE NO. 1 DECK BOARD REINFORCEMENT
Remove the 3 bolts and No. 1 deck board reinforcement.
REMOVE REAR NO. 1 SPEAKER BRACKET
Remove the 2 nuts and rear No. 1 speaker bracket.
REMOVE REAR NO. 3 SPEAKER ASSEMBLY
Disconnect the connector.
Remove the 3 nuts and rear No. 3 speaker assembly.