STEREO COMPONENT AMPLIFIER REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. REMOVE REAR DECK FLOOR BOX (w/ Navigation System for HDD)


    1. A01NDSY

      Remove the 3 clips and the rear deck floor box.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Click here.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE DECK BOARD SUB-ASSEMBLY


    1. A01NFKA

      Disengage the 3 fasteners as shown in the illustration.

    2. for Compact Spare Tire:


      1. A01NGS3

        Remove the 2 bolts and remove the deck board sub-assembly.

    3. for Full Size Spare Tire:


      1. A01NEZN

        Remove the 2 bolts and remove the deck board sub-assembly.

  5. REMOVE SPARE WHEEL COVER ASSEMBLY (for Compact Spare Tire)


    1. Remove the spare wheel cover assembly.

  6. REMOVE NO. 4 REAR FLOOR BOARD (for Compact Spare Tire)


    1. A01NGX9

      Disengage the 2 guides and remove the No. 4 rear floor board.

  7. REMOVE NO. 4 REAR FLOOR BOARD (for Full Size Spare Tire)


    1. A01ND4C

      Disengage the 2 guides and remove the No. 4 rear floor board.

  8. REMOVE NO. 3 REAR FLOOR BOARD (for Compact Spare Tire)


    1. A01NFBL

      Disengage the 2 guides and remove the No. 3 rear floor board.

  9. REMOVE NO. 3 REAR FLOOR BOARD (for Full Size Spare Tire)


    1. A01ND35

      Disengage the 2 guides and remove the No. 3 rear floor board.

  10. REMOVE TONNEAU COVER ASSEMBLY


    1. Remove the tonneau cover assembly.

  11. REMOVE DECK SIDE TRIM BOX LH (for Compact Spare Tire)


    1. A01NGES

      Remove the 2 clips and the deck side trim box LH.

  12. REMOVE DECK SIDE TRIM BOX LH (for Full Size Spare Tire)


    1. A01NDD3

      Remove the 3 clips and the deck side trim box LH.

  13. REMOVE DECK SIDE TRIM BOX RH (for Compact Spare Tire)


    1. A01NHZ2

      Remove the 2 clips and deck side trim box RH.

  14. REMOVE DECK SIDE TRIM BOX RH (for Full Size Spare Tire)


    1. A01NE2M

      Remove the 3 clips and the deck side trim box RH.

  15. REMOVE FRONT DECK FLOOR BOX


    1. A01NH34

      Remove the clip and the front deck floor box.

  16. REMOVE REAR FLOOR FINISH PLATE


    1. A01NCOE

      Disengage the 2 claws, 6 clips and 2 guides, and remove the rear floor finish plate.

  17. REMOVE REAR FLOOR FINISH SIDE PLATE LH


    1. A01ND4W

      Remove the clip.

    2. Disengage the claw and 2 clips.

    3. Disengage the guide and remove the rear floor finish side plate LH.

  18. REMOVE REAR SEAT ASSEMBLY LH

    Tech Tips

    Refer to the procedure up to Remove Rear Seat Assembly Click here.

  19. REMOVE REAR DOOR SCUFF PLATE LH


    1. A01NEW9

      Disengage the 6 claws, 3 clips and guide, and remove the rear door scuff plate LH.

  20. REMOVE REAR SEAT SIDE COVER LH


    1. A01NFWF

      Remove the 2 clips.

    2. Disengage the 2 claws and 3 clips, and remove the rear seat side cover LH.

      Tech Tips

      A part of the clip remains on the vehicle side.

  21. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for LH Side)


    1. A01NFZ5

      Remove the No. 1 luggage compartment trim hook as shown in the illustration.

  22. REMOVE ROPE HOOK ASSEMBLY (for LH Side)


    1. A01NGK2E01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, disengage the 2 claws.

      Tech Tips

      Tape the screwdriver tip before use.

    2. Remove the 2 bolts and the 2 rope hook assemblies.

  23. REMOVE RECLINING REMOTE CONTROL BEZEL LH


    1. A01NG5VE01

      Using moulding remover A, disengage the 2 bottom claws of the reclining remote control bezel LH.

    2. Lift the reclining remote control bezel LH as shown by the arrow (1) in the illustration.

    3. Turn the reclining remote control bezel LH as shown by the arrow (2) in the illustration, then disengage the 2 upper claws and remove the bezel.

  24. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH


    1. Remove the 2 screws.

    2. Remove the 4 clips.

    3. Disengage the 5 claws and 2 clips.

    4. Disconnect each connector and remove the deck trim side panel assembly LH.

      A01NHT1

  25. REMOVE REAR FLOOR FINISH SIDE PLATE RH

    Tech Tips

    Use the same procedure for the RH side and the LH side Click here.

  26. REMOVE REAR SEAT ASSEMBLY RH

    Tech Tips

    Refer to the procedure up to Remove Rear Seat Assembly Click here.

  27. REMOVE REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure for the RH side and the LH side Click here.

  28. REMOVE REAR SEAT SIDE COVER RH

    Tech Tips

    Use the same procedure for the RH side and the LH side Click here.

  29. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side)


    1. A01NFZ5

      Remove the No. 1 luggage compartment trim hook as shown in the illustration.

  30. REMOVE ROPE HOOK ASSEMBLY (for RH Side)

    Tech Tips

    Use the same procedure for the RH side and the LH side Click here.

  31. REMOVE RECLINING REMOTE CONTROL BEZEL RH

    Tech Tips

    Use the same procedure for the RH side and the LH side Click here.

  32. REMOVE HEIGHT CONTROL SWITCH (w/ Air Suspension)


    1. A01NH52

      Disengage the 2 claws to remove the height control switch from the deck trim side panel assembly RH.

    2. Disconnect the connector.

  33. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH


    1. Remove the 2 screws.

    2. Remove the 5 clips.

    3. Disengage the 5 claws and 2 clips.

    4. Disconnect the connector and remove the deck trim side panel assembly RH.

      A01NFKB

  34. REMOVE NO. 1 DECK BOARD REINFORCEMENT


    1. A01NHF9

      Remove the 3 bolts and No. 1 deck board reinforcement.

  35. REMOVE NO. 2 DECK BOARD REINFORCEMENT


    1. A01NDAP

      Remove the 3 bolts and No. 2 deck board reinforcement.

  36. REMOVE REAR SEAT SUB FLOOR PANEL ASSEMBLY


    1. A01NG30

      Disconnect the connector.

    2. Disengage the 6 clamps and disconnect the wire harness.

    3. Remove the 4 bolts and rear seat sub floor panel assembly.

  37. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET


    1. A01NDOE

      Disconnect the 4 connectors.

    2. Remove the bolt, nut and stereo component amplifier assembly with bracket.

  38. REMOVE NO. 2 AMPLIFIER BRACKET


    1. A01NGP6

      Remove the 2 bolts and No. 2 amplifier bracket.

  39. REMOVE NO. 1 AMPLIFIER BRACKET


    1. A01NEIK

      Remove the 2 bolts and No. 1 amplifier bracket.