REAR SEAT ENTERTAINMENT SYSTEM Display Mode Signal Circuit between Multi-display Controller and Television Display Assembly

DESCRIPTION

This is the display mode signal circuit from the multi-display controller sub-assembly to the television display assembly.

WIRING DIAGRAM

A01NFNWE03

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER - TELEVISION DISPLAY ASSEMBLY)


    1. A01NHBAE11

      Disconnect the multi-display controller sub-assembly connector.

    2. A01NHJ2E17

      Disconnect the television display assembly RH connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G16-25 (MD0) - Z21-6 (MD0) Always Below 1 Ω
      G16-25 (MD0) - Body ground Always 10 kΩ or higher
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Multi-display Controller Sub-assembly)
      *2

      Front view of wire harness connector

      (to Television Display Assembly RH)

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here