REAR SEAT ENTERTAINMENT SYSTEM Multi-display Controller Power Source Circuit

DESCRIPTION

This is the power source circuit of the multi-display controller sub-assembly.

WIRING DIAGRAM

A01NF5TE01

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY POWER SOURCE)


    1. A01NHBAE09
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Multi-display Controller Sub-assembly)

      Disconnect the multi-display controller sub-assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G16-21 (GND) - Body ground Always Below 1 Ω
      G16-22 (GND5) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      G16-14 (+B) - G16-21 (GND) Always 11 to 14 V
      G16-28 (+B1) - G16-21 (GND) Always 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here