AUDIO AND VISUAL SYSTEM (w/o Navigation System) Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier

DESCRIPTION

The radio receiver assembly sends sound signals to the stereo component amplifier assembly through this circuit.

The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.

WIRING DIAGRAM

A01NDZRE01

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)


    1. A01NHCZE54
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Radio Receiver Assembly)
      *2

      Front view of wire harness connector

      (to Stereo Component Amplifier Assembly)

      Disconnect the radio receiver assembly and stereo component amplifier assembly connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G7-9 (L+) - O33-3 (L+) Always Below 1 Ω
      G7-19 (L-) - O33-2 (L-) Always Below 1 Ω
      G7-8 (R+) - O33-5 (R+) Always Below 1 Ω
      G7-18 (R-) - O33-4 (R-) Always Below 1 Ω
      G7-9 (L+) - Body ground Always 10 kΩ or higher
      G7-19 (L-) - Body ground Always 10 kΩ or higher
      G7-8 (R+) - Body ground Always 10 kΩ or higher
      G7-18 (R-) - Body ground Always 10 kΩ or higher
      G7-10 (SLD) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here