SLIDING ROOF SWITCH ASSEMBLY INSPECTION


  1. INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)


    1. A01NELAE01
      Text in Illustration
      *1

      Component without harness connected

      (Sliding Roof Switch (Map Light Assembly))

      Remove the sliding roof switch (map light assembly).

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      T10-13 (DOWN) - T10-40 (GND) TILT DOWN switch is pressed Below 1 Ω
      T10-13 (DOWN) - T10-40 (GND) TILT DOWN switch is not pressed 10 kΩ or higher
      T10-14 (UP) - T10-40 (GND) TILT UP switch is pressed Below 1 Ω
      T10-14 (UP) - T10-40 (GND) TILT UP switch is not pressed 10 kΩ or higher
      T10-38 (CLS) - T10-40 (GND) SLIDE CLOSE switch is pressed Below 1 Ω
      T10-38 (CLS) - T10-40 (GND) SLIDE CLOSE switch is not pressed 10 kΩ or higher
      T10-37 (OPN) - T10-40 (GND) SLIDE OPEN switch is pressed Below 1 Ω
      T10-37 (OPN) - T10-40 (GND) SLIDE OPEN switch is not pressed 10 kΩ or higher

      If the result is not as specified, replace the sliding roof switch (map light assembly).