SLIDING ROOF HOUSING REMOVAL


  1. REMOVE ROOF HEADLINING ASSEMBLY

    Tech Tips

    Refer to the procedure up to Remove Roof Headlining Assembly Click here.

  2. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

    CAUTION:

    When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Using a screwdriver with the tip wrapped with protective tape, disconnect the curtain shield airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    4. Remove the 10 bolts.

      A01NFGR

    5. Disengage the 10 hooks to remove the curtain shield airbag assembly.

  3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side and LH side.

  4. REMOVE SLIDING ROOF SIDE GARNISH LH


    1. A01NHIM

      Disengage the 5 claws and remove the sliding roof side garnish LH.

  5. REMOVE SLIDING ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure for the RH side and LH side.

  6. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


    1. A01NE2T

      Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.

  7. REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY


    1. Disconnect the 4 sliding roof drain hoses.

    2. Remove the 4 bolts, 8 nuts and sliding roof housing sub-assembly.

      A01NGGH