POWER WINDOW CONTROL SYSTEM Key-off Operation Function Operates even if Operating Conditions are not Satisfied

DESCRIPTION

• When the front doors are closed, each power window regulator motor assembly can control its power window operation for approximately 45 seconds after the power switch is turned from on (IG) to off by receiving operation permission signals from the main body ECU (multiplex network body ECU).

• However, when approximately 45 seconds have elapsed, or the driver side door or front passenger side door is opened within approximately 45 seconds of the power switch being turned off, the power window regulator motor assembly stops operating.

• During an auto operation, when 45 seconds have passed and key-off operation is prohibited, the window operation will not stop until the auto operation is completed.

INSPECTION PROCEDURE

PROCEDURE

1. CHECK MANUAL UP / DOWN FUNCTION

   
   

   1. Check that the manual up and down function using the multiplex network master switch assembly and power window regulator switch assembly can operate all the power windows Click here.

      OK
      Manual up and down function is normal.

   
   

   NG

   GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) Click here

   OK

2. CHECK REMOTE UP / DOWN FUNCTION

   
   

   1. Check that the remote up and down function using the multiplex network master switch assembly operates the power windows Click here).

      OK
      Remote up and down function is normal.

   
   

   NG

   GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) Click here

   OK

3. CHECK OPERATION FUNCTION AFTER POWER SWITCH IS TURNED OFF

   
   

   1. Check the power window operation function after the power switch is turned off.

      Result

      Result Proceed to When power window can still be operated even after opening driver side door or front passenger side door within approximately 45 seconds of power switch being turned off A When power window can still be operated even after approximately 45 seconds have elapsed after power switch is turned off (for All Doors) B When power window can still be operated even after approximately 45 seconds have elapsed after power switch is turned off (for Driver Side Front Passenger Side, Rear LH Side or Rear RH Side)) C*

      Tech Tips

      *: Replace the power window regulator motor assembly Click here for Front Door, Click here for Rear Door) for the window that still operates when more than 45 seconds have elapsed after the power switch was turned off.

   
   

   B

   REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

   C

   REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (APPLICABLE LOCATION)

   A

4. READ VALUE USING INTELLIGENT TESTER (Main Body)

   
   

   1. Connect the intelligent tester to the DLC3.

   2. Turn the power switch on (IG).

   3. Turn the intelligent tester on.

   4. Enter the following menus: Body / Main Body / Data List.

   5. Read the Data List according to the display on the intelligent tester.

      Main Body (Main Body ECU (Multiplex Network Body ECU))

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      FR Door Courtesy SW	Front door courtesy switch RH signal / ON or OFF	ON: Front door RH open OFF: Front door RH closed	-
      FL Door Courtesy SW	Front door courtesy switch LH signal / ON or OFF	ON: Front door LH open OFF: Front door LH closed	-

      OK
      On the intelligent tester screen, ON or OFF is displayed accordingly.

   
   

   NG

   GO TO LIGHTING SYSTEM (Proceed to Door Courtesy Light Switch Circuit) Click here

   OK

   REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here