ROOF SUNSHADE REMOVAL


  1. REMOVE ROOF HEADLINING ASSEMBLY


    1. Remove the roof headlining assembly Click here.

  2. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

    CAUTION:

    When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Using a screwdriver with the tip wrapped with protective tape, disconnect the curtain shield airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    4. Remove the 10 bolts.

      A01NFGR

    5. Disengage the 10 hooks to remove the curtain shield airbag assembly.

  3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side and the LH side.

  4. REMOVE SLIDING ROOF HOUSING


    1. Remove the 12 nuts and the sliding roof housing.

      A01NEO9