HEATER WATER PUMP INSTALLATION


  1. INSTALL HEATER WATER PUMP ASSEMBLY


    1. A01NG1S

      Install the heater water pump assembly with the 2 bolts.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    2. Connect the connector.

    3. A01NEMA

      Install the 2 heater water hoses with the 2 clips.

    4. A01NEJA

      Install the bolt and engage the wire harness.

      CAUTION:

      Wear insulating gloves.

  2. INSTALL AIR CLEANER ASSEMBLY

    Tech Tips

    Refer to the procedure for Install Air Cleaner Assembly Click here.

  3. INSTALL SERVICE PLUG GRIP

    CAUTION:

    Wear insulated gloves.

    Note

    Before connecting the service plug, check that no parts and tools remain and that the high voltage terminals and connectors are connected securely.


    1. A01NHEW

      Wear insulated gloves and insert the service plug grip in the order shown in the illustration.

    2. Tilt the service plug grip 90° and slide it down until a click sound is heard.

  4. INSTALL BATTERY SERVICE HOLE COVER


    1. A01NG1N

      Engage the 2 clips, 2 guides and install the battery service hole cover.

      Note

      Make sure that the battery service hole cover is installed securely.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL REAR DECK FLOOR BOX


    1. A01NDSY

      Install the rear deck floor box with the 3 clips.