AIR CONDITIONING PRESSURE SENSOR REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM


    1. Turn the A/C switch on.

    2. Operate the A/C with the setting temperature at 25°C (77°F) and the blower level at LO for 10 minutes to circulate the refrigerant. This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.

    3. Turn the power switch off.

    4. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

  3. REMOVE REAR DECK FLOOR BOX


    1. A01NDSY

      Remove the 3 clips and the rear deck floor box.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE ENGINE ROOM SIDE COVER


    1. A01NHKG

      Remove the 4 clips and engine room side cover.

  6. REMOVE AIR CONDITIONING PRESSURE SENSOR


    1. A01NDCL

      Disengage the clamp.

    2. A01NHK8

      Disconnect the connector.

    3. Remove the air conditioning pressure sensor.

      Note

      Do not deform the piping.