COMPRESSOR INSPECTION


  1. INSPECT COMPRESSOR WITH MOTOR ASSEMBLY

    CAUTION:


    • Because the compressor has a high-voltage circuit, wear insulated gloves and pull out the service plug grip to cut off the high-voltage circuit before inspection.

    • Do not touch the high-voltage connectors or terminals for 10 minutes after the service plug grip is removed.

    Note

    Do not start the engine with the service plug grip removed because it may cause a malfunction.


    1. A01NDLUE02
      Text in Illustration
      *1

      Component without harness connected

      (Compressor with motor assembly)

      Disconnect the compressor with motor assembly connector.

    2. Using a megohmmeter, measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (PE) - Body ground Always 2 MΩ or higher
      2 (PB) - Body ground Always 2 MΩ or higher

      If the resistance is not as specified, replace the compressor with motor assembly.