POWER BACK DOOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the power back door system.

  • *1: Use the intelligent tester.

  • *2: for models with the "PBD Assist Open Operation" customize setting item.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS

    Tech Tips


    • In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

    • Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

    • The following 5 items are important points in problem analysis:

    What Vehicle model, system name
    When Date, time, occurrence frequency
    Where Road conditions
    Under what conditions? Running conditions, driving conditions, weather conditions
    How did it happen? Problem symptoms

    NEXT

  3. INSPECT AUXILIARY BATTERY VOLTAGE


    1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.


      NEXT

  4. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*1


    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output B

      B

      GO TO CAN COMMUNICATION SYSTEM Click here

      A

  5. CHECK FOR DTC (WIRELESS DOOR LOCK CONTROL SYSTEM)*1


    1. Clear the DTCs Click here.

    2. Recheck for DTCs.

      Result
      Result Proceed to
      No DTCs are output A
      Wireless door lock control system DTC is output (DTC B1242) B

      B

      GO TO WIRELESS DOOR LOCK CONTROL SYSTEM Click here

      A

  6. CHECK FOR DTC (ENTRY AND START SYSTEM (for Entry Function))*1, 2


    1. Clear the DTCs Click here.

    2. Recheck for DTCs.

      Result
      Result Proceed to
      No DTCs are output A
      Entry and start system (for entry function) DTC is output (DTC B27A8) B

      B

      GO TO ENTRY AND START SYSTEM (for Entry Function) Click here

      A

  7. CHECK FOR DTC*1


    1. Clear the DTCs Click here.

    2. Recheck for DTCs.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

      B

      GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

      A

  8. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

      B

      Go to step 10
      A

  9. OVERALL ANALYSIS AND TROUBLESHOOTING*1


    1. Operation Check Click here

    2. Terminals of ECU Click here

    3. Data List / Active Test Click here


      NEXT

  10. ADJUST, REPAIR OR REPLACE


    NEXT

  11. CONFIRMATION TEST


    NEXT
    END