ELECTRONICALLY CONTROLLED BRAKE SYSTEM TRC OFF Indicator Light does not Come ON

DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to TRC OFF Indicator Light Remains ON Click here.

INSPECTION PROCEDURE

Note

When replacing the skid control ECU, perform initialization and calibration of the linear solenoid valve Click here.

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if a CAN communication system DTC is output Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B

    INSPECT CAN COMMUNICATION SYSTEM Click here

    A

  2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TRC OFF INDICATOR)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Select the Active Test on the intelligent tester Click here.

      ABS/VSC/TRC
      Tester Display Test Part Control Range Diagnostic Note
      TRC OFF Indicator Light Multi-information display (TRC OFF indicator) Display ON/OFF Observe combination meter

    4. Check that the multi-information display (TRC OFF indicator) on the combination meter turns on or off in accordance with the intelligent tester operation.

      OK
      The multi-information display (TRC OFF indicator) turns on or off in accordance with the intelligent tester operation.

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part Click here.


    NG

    INSPECT COMBINATION METER ASSEMBLY Click here

    OK

    REPLACE SKID CONTROL ECU Click here

  3. INSPECT COMBINATION METER ASSEMBLY


    1. Turn the power switch off.

    2. Perform the Active Test of the combination meter (meter CPU) using the intelligent tester Click here.

    3. Check the combination meter.

      OK
      The multi-information display turns on or off in accordance with the intelligent tester operation.

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step Click here.


    NG

    REPLACE COMBINATION METER ASSEMBLY Click here

    OK

    REPLACE SKID CONTROL ECU Click here