REAR ACTIVE STABILIZER CONTROL ACTUATOR REMOVAL


  1. REMOVE REAR STABILIZER LINK SUB-ASSEMBLY


    1. Remove the rear stabilizer link sub-assembly (LH Side).


      1. A01NHUOE01

        Remove the 2 nuts (A) and separate the rear stabilizer link sub-assembly from the rear No. 2 suspension arm assembly LH.

      2. Remove the nut (B) and separate the rear stabilizer link sub-assembly with rear lower stabilizer bracket.

        Tech Tips

        If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

      3. A01NFTZ

        Hold the rear lower stabilizer bracket between aluminium plates in a vise as shown in the illustration.

        Note

        Do not overtighten the vise.

      4. Remove the nut and rear stabilizer link sub-assembly from the rear lower stabilizer bracket.

        Tech Tips

        If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

    2. Remove the rear stabilizer link sub-assembly (RH Side).

      Tech Tips

      Perform the same procedure as the LH side.

  2. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH (w/ Rear Fender Mudguard)


    1. A01NDHL

      Using a 4 mm hexagon wrench, remove the 3 hexagon screws.

    2. A01NFP7

      Remove the 2 screws and rear quarter panel mudguard sub-assembly.

  3. REMOVE NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR


    1. A01NGGR

      Remove the 2 screws and grommet.

    2. A01NGGW

      Remove the 4 screws.

    3. Remove the 2 bolts and 3 clips.

    4. Disengage the 2 claws and remove the No. 2 luggage compartment side cover protector.

  4. REMOVE REAR ACTIVE STABILIZER CONTROL ACTUATOR ASSEMBLY


    1. A01NH2OE01

      Disengage the 2 clamps and disconnect the connector (A).

    2. Using the procedures below, disconnect the connector (B).


      1. Using a screwdriver, release the lever's lock.*1

      2. Move the lever in the direction of the arrow in the illustration.*2

      3. Disconnect the ECU connector.*3

        Note

        When disconnecting the connector, do not apply excessive force to the wire harness.

    3. A01NDYE

      Remove the 4 nuts and rear active stabilizer control actuator assembly with 2 rear stabilizer bushings and 2 rear No. 1 stabilizer bar brackets.

      Note


      • Take care not to damage the wire harness and connectors of the rear active stabilizer control actuator assembly.

      • Avoid any impact to the rear active stabilizer control actuator assembly.

      • Do not drop the rear active stabilizer control actuator assembly. If it is dropped, replace it with a new one.

  5. REMOVE REAR NO. 1 STABILIZER BAR BRACKET


    1. A01NE68

      Remove the 2 rear No. 1 stabilizer bar brackets from the 2 rear stabilizer bushings.

  6. REMOVE REAR STABILIZER BUSHING


    1. A01NHPL

      Remove the 2 rear stabilizer bushings from the rear active stabilizer control actuator assembly.