REAR STABILIZER BAR INSTALLATION


  1. INSTALL REAR STABILIZER BUSHING


    1. A01NGMRE01
      Text in Illustration
      *1 Stopper

      Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.

  2. INSTALL REAR NO. 1 STABILIZER BAR BRACKET


    1. A01NCMLE01
      Text in Illustration
      *1 Identification Shape
      *2 Identification Mark

      Install the 2 rear No. 1 stabilizer bar brackets to the rear stabilizer bushings.

      Note


      • Ensure that the identification shape faces upward.

      • Ensure that the identification mark is on the right side of the vehicle.

  3. INSTALL REAR STABILIZER BAR


    1. A01NDVJE01
      Text in Illustration
      *1 Identification Mark

      Install the rear stabilizer bar with 2 rear stabilizer bushings and 2 rear No. 1 stabilizer bar brackets with the 4 nuts.

      Torque:
      75 N*m  { 765 kgf*cm, 55 ft.*lbf }

      Note

      Ensure that the identification mark is on the right side of the vehicle.

  4. INSTALL REAR STABILIZER LINK SUB-ASSEMBLY


    1. Install the rear stabilizer link sub-assembly (LH Side).


      1. A01NFTZ

        Hold the rear lower stabilizer bracket between aluminium plates in a vise as shown in the illustration.

        Note

        Do not overtighten the vise.

      2. Install the rear stabilizer link sub-assembly to the rear lower stabilizer bracket as shown in the illustration.

        Torque:
        92 N*m  { 938 kgf*cm, 68 ft.*lbf }

        Tech Tips

        If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

      3. A01NHUOE01

        Install the rear stabilizer link sub-assembly to the rear stabilizer bar with the nut (B).

        Torque:
        90 N*m  { 918 kgf*cm, 66 ft.*lbf }

        Tech Tips

        If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

      4. Install the rear stabilizer link sub-assembly with rear lower stabilizer bracket to the rear No. 2 suspension arm assembly LH with the 2 nuts (A).

        Torque:
        82 N*m  { 836 kgf*cm, 60 ft.*lbf }

    2. Install the rear stabilizer link sub-assembly (RH Side).

      Tech Tips

      Perform the same procedure as the LH side.