REAR UPPER ARM INSTALLATION


  1. INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH


    1. A01NGD3

      Temporarily install the rear upper control arm assembly LH to the rear suspension member sub-assembly with the bolt and nut.

      Note


      • Insert the bolt with the threaded end facing the rear of the vehicle.

      • Since the stopper nut is used, tighten the bolt.

    2. A01NFJIE01

      Set the rear upper control arm assembly LH in the tightening position as shown in the illustration.

      Standard length (A)
      24.3 mm (0.957 in.)
    3. A01NGD3

      Fully tighten the bolt in the tightening position.

      Torque:
      120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

      Note

      Since the stopper nut is used, tighten the bolt.

  2. INSTALL REAR UPPER CONTROL ARM ASSEMBLY RH

    Tech Tips

    Perform the same procedure as the LH side.

  3. INSTALL REAR SPEED SENSOR LH


    1. A01NGFP

      Install the rear speed sensor LH to the rear upper control arm assembly LH with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      Do not twist the rear speed sensor LH when installing it.

  4. INSTALL REAR SPEED SENSOR RH


    1. A01NDZ7

      Install the rear speed sensor RH to the rear upper control arm assembly RH with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      Do not twist the rear speed sensor RH when installing it.

  5. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH


    1. A01ND79

      Install the rear height control sensor sub-assembly RH to the rear upper control arm assembly RH with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  6. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Air Suspension)


    1. A01NCXK

      Install the rear height control sensor sub-assembly LH to the rear upper control arm assembly LH with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  7. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Tech Tips

    Refer to the procedures from Install Rear Suspension Member Sub-assembly Click here.