FRONT ACTIVE STABILIZER CONTROL ACTUATOR INSPECTION


  1. INSPECT FRONT STABILIZER LINK ASSEMBLY


    1. A01NGE2

      Inspect the turning torque of the ball joint.


      1. Secure the front stabilizer link assembly in a vise using aluminum plates.

      2. Install the nut to the front stabilizer link assembly stud.

      3. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

        Turning torque
        0.05 to 1.96 N*m (0.5 to 20 kgf*cm, 0.4 to 17 in.*lbf)

        If the turning torque is not within the specified range, replace the front stabilizer link assembly with a new one.

    2. Inspect the dust cover.


      1. Check that the dust cover is not cracked and that there is no grease on it.