HEIGHT CONTROL SWITCH (for Driver Seat) INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for the LHD vehicle.


  1. INSTALL HEIGHT CONTROL SWITCH


    1. A01NGTB

      Engage the 2 claws to install the height control switch to the lower instrument panel finish panel sub-assembly.

  2. INSTALL NO. 1 SWITCH HOLE BASE


    1. Connect each connector.

    2. A01NFF7

      Engage the 4 claws and 2 guides to install the No. 1 switch hole base.

  3. INSTALL INSTRUMENT PANEL GARNISH LH


    1. A01NH3A

      Engage the 6 clips to install the instrument panel garnish LH.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL REAR DECK FLOOR BOX


    1. A01NDSY

      Install the rear deck floor box with the 3 clips.

  6. PERFORM INITIALIZATION


    1. Perform initialization Click here.

  7. INSPECT SUSPENSION CONTROL SYSTEM


    1. Inspect the suspension control system Click here.