HEIGHT CONTROL SENSOR (for Front Side) INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    1. A01NE5Y

      Install the front height control sensor sub-assembly with the 2 nuts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

      Note

      Do not drop the height control sensor. If the sensor is dropped, replace it with a new one.

    2. A01NE12

      Connect the connector.

    3. A01NE57

      Install the height control sensor link onto the front lower suspension arm with the nut.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  2. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL REAR DECK FLOOR BOX


    1. A01NDSY

      Install the rear deck floor box with the 3 clips.

  5. CHECK VEHICLE HEIGHT

    Note

    If the height control sensor link is removed, check the vehicle height.


    1. Change the height control switch from the "NORMAL" position to the "HIGH" position and back to the "NORMAL" position.

    2. Measure the vehicle height Click here.

  6. ADJUST VEHICLE HEIGHT

    Note

    If the height control sensor has been replaced, be sure to adjust the vehicle height.


    1. Adjust the vehicle height Click here.

  7. PERFORM INITIALIZATION


    1. Perform initialization Click here.

  8. ADJUST HEADLIGHT ASSEMBLY (for HID Headlight)


    1. Adjust the headlight Click here.

  9. ADJUST HEADLIGHT ASSEMBLY (for LED Headlight)


    1. Adjust the headlight Click here.