ACTIVE STABILIZER CONTROL ECU REMOVAL

PRECAUTION (w/ Navigation System for HDD)

Note

After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
Specification	Waiting Time
w/o Telematics transceiver	60 sec.
w/ Telematics transceiver	120 sec.

REMOVE REAR DECK FLOOR BOX
1. Remove the 3 clips and the rear deck floor box.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
1. Remove the 2 screws and grommet.
2. Remove the 4 screws.
3. Remove the 2 bolts and 3 clips.
4. Disengage the 2 claws and remove the No. 2 luggage compartment side cover protector.
REMOVE ACTIVE STABILIZER CONTROL ECU ASSEMBLY
1. Remove the bolt and ground wire from the active stabilizer ECU bracket.
2. As shown in the illustration, disconnect the 3 clamps and each connector to separate the wire harness from the active stabilizer control ECU assembly.
  
  Text in Illustration
  
  *1 Rear of the vehicle
3. Text in Illustration
  
  *1 Rear of the vehicle
  
  Remove the 3 nuts, clip and active stabilizer control ECU assembly from the active stabilizer ECU bracket.
  Note
  - Avoid any impact to the active stabilizer control ECU assembly.
  - Do not drop the active stabilizer control ECU assembly. If the ECU is dropped, replace it with a new one.
REMOVE ACTIVE STABILIZER ECU BRACKET
1. Remove the 3 bolts and active stabilizer ECU bracket.