| DTC Code | DTC Name |
|---|---|
| C194F | Operation of Static Test Mode is Incomplete (Test Mode DTC) |
| C1950 | Front Stabilizer Target Angle Not Attained (Test Mode DTC) |
| C1951 | Rear Stabilizer Target Angle Not Attained (Test Mode DTC) |
DESCRIPTION
If the Active Test does not operate, test mode DTCs C194F and C1950 are output for the front, and C194F and C1951 are output for the rear. If system malfunction DTCs are already stored, test mode DTCs are not stored. During the Active Test, if the power switch is turned off or an actuator is malfunctioning, test mode DTCs are stored due to incompletion of operation. If this occurs, turn the power switch off (unless already turned off) and turn the power switch on (READY). Then perform the Active Test to complete the operation normally, and the test mode DTC will be cleared.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C194F | Active Test incomplete | Perform Active Test again |
| C1950 | During Active Test, front active stabilizer control actuator assembly does not operate to target angle |
|
| C1951 | During Active Test, rear active stabilizer control actuator assembly does not operate to target angle |
|
INSPECTION PROCEDURE
PROCEDURE
PERFORM ACTIVE TEST USING INTELLIGENT TESTER
Turn the power switch off.
Connect the intelligent tester to the DLC3.
Turn the power switch on (READY) and the intelligent tester on.
Perform the Active Test Click here.
After the Active Test ends, check for test mode DTCs Click here.
| Result | Proceed to |
|---|---|
| Test mode DTC C194F and/or C1950 are output | A |
| Test mode DTC C194F and/or C1951 are output | B |
| Test mode DTCs are not output | C |
| B |
|
GO TO FLOWCHART OF DTC C1901 Click here |
| C |
|
END |
| A |
|
GO TO FLOWCHART OF DTC C1929 Click here