ACTIVE STABILIZER SUSPENSION SYSTEM, Diagnostic DTC:C1901, C1902, C1903, C1904, C191C

DTC Code DTC Name
C1901 Rear Magnetic Pole Sensor Initialization Incomplete
C1902 Rear Magnetic Pole Sensor Pattern
C1903 Rear Actuator Short Detect Relay
C1904 Protection for Overload of Rear Actuator
C191C Rear Actuator Torque Decrease

DESCRIPTION

If a malfunction occurs in the rear active stabilizer control actuator's magnetic pole sensor (motor pulse sensor), the motor short relay or the motor short relay's circuit, DTC C1901, C1902, C1903, C1904 and/or C191C are output.

DTC No. DTC Detection Condition Trouble Area
C1901 During the initial check immediately after turning power switch on (READY), malfunction is detected in rear active stabilizer control actuator's magnetic pole sensor (motor pulse sensor)

  • Harness or connector

  • Rear active stabilizer control actuator assembly

  • Rear active stabilizer control ECU
C1902 Malfunction is detected in rear active stabilizer control actuator's magnetic pole sensor (motor pulse sensor)
C1903 Malfunction is detected in rear active stabilizer control actuator's motor short relay
C1904 During rear active stabilizer control, rear active stabilizer control actuator stuck condition is detected
C191C During rear active stabilizer control, rear active stabilizer control actuator torque insufficient condition is detected

WIRING DIAGRAM

A01NEM3E04

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK CONNECTOR CONNECTION CONDITION


    1. Turn the power switch off.

    2. Check that the wire harness connectors between the rear active stabilizer control ECU and rear active stabilizer control actuator assembly are not loose or disconnected and that the wire harness is not damaged.

      OK
      Connectors are not loose or disconnected. Wire harness is not damaged.

      Tech Tips

      If the wire harness of the rear active stabilizer control actuator assembly is damaged, replace the rear active stabilizer control actuator assembly Click here.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INTERCHANGE FRONT AND REAR ACTIVE STABILIZER CONTROL ECU ASSEMBLY


    1. Turn the power switch off.

    2. Interchange the rear active stabilizer control ECU with the front active stabilizer control ECU, and install them securely Click here.


    NEXT

  3. CLEAR DTC


    1. Turn the power switch off.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the power switch on (IG) and the intelligent tester on.

    4. Clear the DTCs Click here.


    NEXT

  4. CHECK OPERATION OF REAR ACTIVE STABILIZER CONTROL ECU ASSEMBLY


    1. Turn the power switch off.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the power switch on (READY) and wait 30 seconds or more. Then check for front active stabilizer DTCs Click here.

      OK
      DTC C1929, C192A, C192B, C192C and/or C1944 are not output.

      Tech Tips

      Interchange the front and rear active stabilizer control ECUs and check for DTCs. After interchanging the ECUs, if a front active stabilizer DTC is stored, it can be determined that the rear active stabilizer control ECU is malfunctioning. If no DTC is stored, the rear active stabilizer control actuator assembly is malfunctioning.


    NG

    REPLACE ACTIVE STABILIZER CONTROL ECU ASSEMBLY Click here

    OK

    REPLACE REAR ACTIVE STABILIZER CONTROL ACTUATOR ASSEMBLY Click here