SHIFT LEVER INSPECTION


  1. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY


    1. A01NFOGE01
      Text in Illustration
      *1

      Rear view of wire harness connector

      (to Shift Lock Control Unit)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      12 (IG) - 3 (E) Power switch on (IG) 11 to 14 V
      Power switch off Below 1 V
      6 (STP) - 3 (E) Brake pedal depressed 11 to 14 V
      Brake pedal released Below 1 V

      Tech Tips

      Do not disconnect the shift lock control unit assembly connector.

      If the result is not as specified, replace the shift lock control unit assembly.

    2. A01NFOGE02
      Text in Illustration
      *1

      Rear view of wire harness connector

      (to Shift Lock Control Unit)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 (E) - Body ground Always Below 1 Ω

      Tech Tips

      Do not disconnect the shift lock control unit assembly connector.

      If the result is not as specified, replace the shift lock control unit assembly.

  2. INSPECT TRANSMISSION CONTROL SWITCH


    1. A01NGI8E01
      Text in Illustration
      *1

      Component without harness connected

      (Transmission Control Switch)

      Measure the resistance between each terminal of the shift lock control unit assembly when the shift lever is moved to each position.

      Standard Resistance
      Tester Connection Shift Lever Position Specified Condition
      6 (IG) - 13 (S) S, "+" or "-" Below 1 Ω
      Other than S, "+" and "-" 10 kΩ or higher
      5 (SFTU) - 11 (E)

      "+"

      Pressed continuously

      (Upshift)

      		 Below 1 Ω
      S 10 kΩ or higher
      4 (SFTD) - 11 (E)

      "-"

      Pressed continuously

      (Downshift)

      		 Below 1 Ω
      S 10 kΩ or higher

      If the result is not as specified, replace the shift lock control unit assembly.

  3. INSPECT SHIFT LOCK SOLENOID


    1. Disconnect the shift lock solenoid connector.

    2. A01NGSJE01
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Shift Lock Solenoid)

      Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.

      Standard Resistance
      Tester Connection Shift Lever Position Specified Condition
      4 (P) - 3 (E2) P 10 kΩ or higher
      4 (P) - 3 (E2) Other than P Below 1 Ω

      If the result is not as specified, replace the shift lock control unit assembly.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (SLS+) - 2 (SLS-) Always 112 Ω

      If the result is not as specified, replace the shift lock control unit assembly.