MILLIMETER WAVE RADAR SENSOR REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A01NHKG

      Remove the 4 clips and engine room side cover.

  2. REMOVE ENGINE ROOM SIDE COVER LH


    1. A01NH7B

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover LH.

  3. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01NDNO

      Remove the 6 clips and cool air intake duct seal.

  4. REMOVE HOOD CENTER CUSHION


    1. A01NE5D

      Remove the 2 hood center cushions.

  5. REMOVE FRONT BUMPER ASSEMBLY


    1. A01NFTPE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    2. A01ND22

      Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. A01NDQH

      Remove the screw and front bumper seal bracket.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. A01NE3M

      Remove the 2 bolts and 2 screws.

    5. Using a clip remover, remove the 6 clips.

    6. A01NFX1

      Disengage the 4 claws and remove the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    7. A01NE8W

      Using a moulding remover, disengage the claw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    8. Disconnect the fog light connector.

    9. Disconnect the No. 1 ultrasonic sensor connector. (w/ LEXUS Parking Assist-sensor System)

    10. Disconnect the headlight cleaner hose.

      Note

      Prepare a drain pan or a piece of cloth in case washer fluid leaks.

    11. A01NCNT

      Remove the front bumper assembly as shown in the illustration.

  6. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. A01NFIV

      Disconnect the connector.

    2. Remove the 3 bolts and the millimeter wave radar sensor assembly.