DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:C1A10

DTC Code DTC Name
C1A10 Front Radar Sensor

DESCRIPTION

When the driving support ECU receives information that there is a malfunction in the millimeter wave radar sensor assembly, DTC C1A10 is stored.

DTC No. DTC Detection Condition Trouble Area
C1A10 While power switch is on (IG), driving support ECU receives information that there is malfunction in millimeter wave radar sensor assembly for 1 second

  • Millimeter wave radar sensor assembly

  • Driving support ECU

INSPECTION PROCEDURE

Note

When the front millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed Click here.

PROCEDURE


  1. REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. Replace the millimeter wave radar sensor assembly Click here.


    NEXT

  2. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. Adjust the millimeter wave radar sensor assembly Click here.


    NEXT

  3. CHECK WHETHER DTC OUTPUT RECURS


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Clear the DTCs Click here.

    4. Perform the following to make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the malfunction cannot be detected.


      1. Drive the vehicle at a speed of 40 km/h (25 mph) or more.

      2. Turn the cruise control main switch on.

      3. Push the -SET switch to activate the cruise control.

    5. Enter the following menus: Powertrain / Radar Cruise / DTC.

    6. Read the DTCs.

      Result
      Result Proceed to
      DTC is not output A
      DTC C1A10 is output B

    B

    REPLACE DRIVING SUPPORT ECU Click here

    A

    END