POWER SWITCH INSTALLATION


  1. INSTALL POWER SWITCH


    1. A01NGJP

      Connect the power switch connector.

    2. A01NGXD

      Attach the 2 claws to install the power switch.

  2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. A01NG78

      Engage the 8 clips and 2 guides.

    3. Install the lower instrument panel finish panel sub-assembly with the 2 screws <D>.

    4. A01NE1K

      Engage the 2 claws to close the cover as shown in the illustration.

  3. INSTALL NO. 1 SWITCH HOLE BASE


    1. Connect each connector.

    2. A01NFF7

      Engage the 4 claws and 2 guides to install the No. 1 switch hole base.

  4. INSTALL INSTRUMENT PANEL GARNISH LH (for LHD)


    1. A01NH3A

      Engage the 6 clips to install the instrument panel garnish LH.

  5. INSTALL INSTRUMENT PANEL GARNISH RH (for RHD)

    Tech Tips


  6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)


    1. A01NFZB

      Engage the 2 clips to install the cowl side trim sub-assembly LH.

    2. Install the clip.

  7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

    Tech Tips

    Use the same procedure as for the LH side Click here.

  8. INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)


    1. w/ Illumination:


      1. Connect the connector.

    2. A01NHW7

      Engage the 4 clips, guide and 7 claws, and install the front door scuff plate LH.

  9. INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)

    Tech Tips

    Use the same procedure as for the LH side Click here.

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. INSTALL REAR DECK FLOOR BOX


    1. A01NDSY

      Install the rear deck floor box with the 3 clips.