POWER SWITCH REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. REMOVE REAR DECK FLOOR BOX


    1. A01NDSY

      Remove the 3 clips and the rear deck floor box.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)


    1. A01NHW7

      Disengage the 7 claws, 4 clips and guide, and remove the front door scuff plate LH.

      Tech Tips

      A part of the clip remains on the vehicle side.

    2. w/ Illumination:


      1. Disconnect the connector.

  5. REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)

    Tech Tips

    Use the same procedure as for the LH side Click here.

  6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)


    1. A01NFZB

      Remove the clip.

    2. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.

  7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

    Tech Tips

    Use the same procedure as for the LH side Click here.

  8. REMOVE INSTRUMENT PANEL GARNISH LH (for LHD)


    1. A01NGMK

      Using moulding remover B, disengage the 6 clips and remove the instrument panel garnish LH as shown in the illustration.

  9. REMOVE INSTRUMENT PANEL GARNISH RH (for RHD)

    Tech Tips


  10. REMOVE NO. 1 SWITCH HOLE BASE


    1. A01NFNE

      Push the No. 1 switch hole base in the direction indicated by the arrow to disengage the 4 claws and 2 guides.

    2. Disconnect each connector and remove the No. 1 switch hole base.

  11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. A01NGE1

      Disengage the 2 claws and open the cover as shown in the illustration.

    2. A01NG78

      Remove the 2 screws <D>.

    3. Disengage the 8 clips and 2 guides.

    4. Disconnect each connector and remove the lower instrument panel finish panel sub-assembly.

  12. REMOVE POWER SWITCH


    1. A01NGXD

      Detach the 2 claws and remove the power switch.

    2. A01NGJP

      Disconnect the power switch connector.