EGR VALVE INSTALLATION

INSTALL V-BANK COVER SUB-ASSEMBLY

ADD COOLANT (for Engine)

1. Tighten the radiator drain cock plug by hand.

2. Tighten the 2 cylinder block drain cock plugs.

   Torque:

   13 N*m  { 130 kgf*cm, 9 ft.*lbf }

3. Loosen the air drain cock plug on the water inlet housing.

4. Add TOYOTA Super Long Life Coolant (SLLC) to the radiator inlet opening until coolant overflows from the air drain cock hole. Then tighten the air drain cock plug to the water inlet housing.

   Torque:

   13 N*m  { 130 kgf*cm, 9 ft.*lbf }

5. Slowly fill the radiator with TOYOTA Super Long Life Coolant (SLLC).

   Standard Capacity

   Item	Capacity
   Engine coolant	11.7 liters (12.4 US qts, 10.2 lmp. qts)

   Tech Tips

   
   

   • TOYOTA vehicles are filled with TOYOTA SLLC at the factory. In order to avoid damage to the engine cooling system and other technical problems, only use TOYOTA SLLC or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids).

   • Contact your TOYOTA dealer for further details.

   Note

   Never use water as a substitute for engine coolant.

6. 

   Text in Illustration

   *1

   Full Line

   Slowly pour coolant into the radiator reservoir tank until it reaches the full line.

7. Install the radiator cap.

8. Squeeze the No. 1 and No. 2 radiator hoses several times by hand, and then check the level of the coolant.

   If the coolant level is low, add coolant.

9. Bleed air from the cooling system.

   
   

   1. Put the engine in inspection mode Click here.

   2. Warm up the engine until the thermostat opens. While the thermostat is open, circulate the coolant for several minutes.

      Tech Tips

      The thermostat open timing can be confirmed by squeezing the No. 2 radiator hose by hand, and checking when the engine coolant starts to flow inside the hose.

   3. Maintain the engine speed at 2500 rpm.

   4. Squeeze the inlet and No. 1 and No. 2 radiator hoses several times by hand to bleed air.

      CAUTION:

      When squeezing the radiator hoses:

      
      

      • Wear protective gloves.

      • Be careful as the radiator hoses are hot.

      • Keep your hands away from the cooling fans.

      Note

      
      

      • Make sure that the radiator reservoir still has some coolant in it.

      • If the coolant temperature gauge indicates an excessive temperature, turn off the engine and let it cool.

      • If there is not enough coolant, the engine may overheat or be seriously damaged.

      • If the radiator reservoir does not have enough coolant, perform the following: 1) stop the engine, 2) wait until the coolant has cooled down, and 3) add coolant until the reservoir is filled to the Full line.

10. Stop the engine and wait until the engine coolant cools down.

11. Add engine coolant to the full line on the radiator reservoir.

INSPECT FOR COOLANT LEAK (for Engine)

INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY

INSTALL FRONT SHOCK ABSORBER CAP LH (w/ Air Suspension)