FUEL SENDER GAUGE ASSEMBLY INSPECTION


  1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    1. A01NGS1E01
      Text in Illustration
      *1 Front view of wire harness connector

      Remove the fuel sender gauge assembly.

    2. Check that the float moves smoothly between F and E.

    3. Disconnect the fuel sender gauge connector.

    4. Measure the resistance between the terminals 1 (FE) and 2 (FS) of connector according to the value(s) in the table below.

      Standard Resistance
      Float Level Resistance (Ω)
      F 13.5 to 16.5
      E 405.5 to 414.5

      If the value is not as specified, replace the fuel sender gauge assembly.