PCV VALVE REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A01NHKG

      Remove the 4 clips and engine room side cover.

  2. REMOVE ENGINE ROOM SIDE COVER LH


    1. A01NH7B

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover LH.

  3. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01NDNO

      Remove the 6 clips and cool air intake duct seal.

  4. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01NEB5

      Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the 2 retainers on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

      Note

      Attempting to disengage both front and rear retainers at the same time may cause the V-bank cover sub-assembly to break.

  5. REMOVE VENTILATION VALVE SUB-ASSEMBLY


    1. A01NGNV

      Disconnect the ventilation hose from the ventilation valve sub-assembly.

    2. A01NGJ1

      Using a 19 mm deep socket wrench, remove the ventilation valve sub-assembly.