FRONT CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL TIMING CHAIN CASE OIL SEAL


    1. Apply MP grease to a new timing chain case oil seal lip.

      Note

      Keep the lip free from foreign objects.

    2. A01NGVOE01

      Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover edge.

      SST
      09223-22010
      09506-35010
      Oil seal tap in depth
      0 to 1.0 mm (0 to 0.0393 in.)

      Note


      • Keep the lip free of foreign matter.

      • Do not tap the timing chain case oil seal at an angle.

  2. INSTALL CRANKSHAFT TIMING GEAR KEY


    1. A01NCS3

      Align the pulley set key with the key groove of the pulley, and slide on the pulley.

  3. INSTALL CRANKSHAFT PULLEY


    1. A01NGV3E02
      Text in Illustration
      *1 Hold
      *2 Turn

      Using SST, install the pulley bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
      Torque:
      250 N*m  { 2550 kgf*cm, 184 ft.*lbf }

  4. INSTALL V-RIBBED BELT


    1. A01NE88E01
      Text in Illustration
      *1 Water Pump
      *2 Idler
      *3 Crankshaft

      Install the V-ribbed belt.

    2. A01NDRY

      Turn the V-ribbed belt tensioner counterclockwise and remove a 5 mm bi-hexagon wrench.

    3. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.

  5. INSTALL FRONT FENDER APRON SEAL RH

  6. INSTALL FRONT FENDER LINER RH

  7. INSTALL FRONT WHEEL RH


    1. Install the front wheel RH.

      Torque:
      103 N*m  { 1050 kgf*cm, 76 ft.*lbf }