HYBRID BATTERY SYSTEM, Diagnostic DTC:P0AC0-123

DTC Code DTC Name
P0AC0-123 Hybrid Battery Pack Current Sensor Circuit Range / Performance

DESCRIPTION

Refer to the Description for DTC P0ABF-123 Click here.

DTC No. DTC Detection Condition Trouble Area
P0AC0-123 When the battery current sensor is abnormal (1 or 2 trip detection)

  • Hybrid battery junction block assembly

  • Battery smart unit

INSPECTION PROCEDURE

CAUTION:


  • Before inspecting the high-voltage system, take safety precautions to prevent electrical shocks, such as wearing insulated gloves and removing the service plug grip. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.

  • After disconnecting the service plug grip, wait for at least 10 minutes before touching any of the high-voltage connectors or terminals.

    Tech Tips

    At least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

Note

After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
Specification Waiting Time
w/o Telematics transceiver 60 sec.
w/ Telematics transceiver 120 sec.

PROCEDURE


  1. CHECK DTC OUTPUT (DTC P0AFC-123 IS OUTPUT)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

    4. Read output DTCs Click here.

      Result
      Result Proceed to
      P0AFC-123 is not output. A
      P0AFC-123 is also output. B

    5. Disconnect the intelligent tester from the DLC3.


    B

    GO TO DTC CHART

    A

  2. REPLACE HYBRID BATTERY JUNCTION BLOCK ASSEMBLY


    1. Replace the hybrid battery junction block assembly Click here.


    NEXT

  3. CLEAR DTC (HV)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

    4. Clear the DTCs and freeze frame data Click here.

    5. Perform a road test to charge and discharge the HV battery assembly.

      Tech Tips

      2 trip detection logic is used. After the first road test, turn the power switch off and perform a road test again.

    6. Disconnect the intelligent tester from the DLC3.


    NEXT

  4. RECONFIRM DTC OUTPUT (HV)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

    4. Read output DTCs Click here.

      Result
      Result Proceed to
      DTCs P0AC0-123 is not output. A
      DTCs P0AC0-123 is output. B

    5. Disconnect the intelligent tester from the DLC3.


    B

    REPLACE BATTERY SMART UNIT Click here

    A

    RECOVERY TO NORMAL