ECM INSTALLATION


  1. INSTALL ECM


    1. Set the ECM in the engine room ECM box.

    2. A01ND20

      Install the engine room ECM cover with the 3 claws.

    3. A01NH16

      Install the No. 1 ECM bracket and No. 2 ECM bracket with the 4 bolts.

      Torque:
      4.5 N*m  { 46 kgf*cm, 40 in.*lbf }
    4. A01NESE

      Install the wire harness clamp bracket with the 2 bolts.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }
    5. A01NEH4

      Install the ECM with bracket with the 3 bolts.

      Torque:
      19 N*m  { 193 kgf*cm, 14 ft.*lbf }
    6. A01NEPX

      Install the cooler pipe with the bolt.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }
    7. A01NDIV

      Connect the 2 ECM connectors and lower the 2 levers.

      Note


      • When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors and other parts.

      • Make sure that the 2 levers are securely locked.

    8. A01NDZ3

      Install the 2 wire harness clamps.

  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. INSTALL REAR DECK FLOOR BOX


    1. A01NDSY

      Install the rear deck floor box with the 3 clips.

  4. INSTALL COOL AIR INTAKE DUCT SEAL


    1. A01NCUN

      Install the cool air intake duct seal with the 6 clips.

  5. INSTALL ENGINE ROOM SIDE COVER


    1. A01NGSF

      Install the engine room side cover with the 4 clips.

  6. INSTALL ENGINE ROOM SIDE COVER LH


    1. A01NFNX

      Install the engine room side cover with the 4 clips.

  7. PERFORM INITIALIZATION

    Tech Tips

    Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.


    1. Perform Initialization when replacing the ECM Click here.