SFI SYSTEM (w/ EGR System), Diagnostic DTC:P2610

DTC Code DTC Name
P2610 ECM / PCM Internal Engine Off Timer Performance

DESCRIPTION

The soak timer operates after the power switch is turned off. When a certain amount of time has elapsed after turning the power switch off, the soak timer activates the ECM to perform malfunction checks which can only be performed after the engine is stopped. The soak timer is built into the ECM.

A01NCZUE03
DTC No. DTC Detection Condition Trouble Area
P2610

ECM internal malfunction while engine running

(2 trip detection logic)

 ECM

MONITOR DESCRIPTION

If the soak timer activates the ECM even though only a short amount of time has elapsed since the power switch was turned off, or if the soak timer does not activate the ECM even though a considerable amount of time has elapsed since the power switch was turned off, the ECM determines that the soak timer is malfunctioning, illuminates the MIL and stores a DTC the next time the power switch is turned on (IG).

INSPECTION PROCEDURE

Tech Tips


  • DTC P2610 is set if an internal ECM problem is detected. Diagnostic procedures are not required. ECM replacement is required.

  • Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE


  1. REPLACE ECM


    1. Replace the ECM Click here.


    NEXT

  2. CHECK WHETHER DTC OUTPUT RECURS


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the tester on.

    4. Clear the DTCs Click here.

    5. Put the engine in inspection mode Click here.

    6. Start the engine and wait for 10 minutes or more.

    7. Enter the following menus: Powertrain / Engine and ECT / DTC / Pending.

    8. If no pending DTC is displayed, the repair has been successfully completed.


    NEXT

    END