SFI SYSTEM (w/o EGR System) PRECAUTION


  1. PRECAUTIONS FOR INSPECTING HYBRID CONTROL SYSTEM


    1. Before inspecting the high-voltage system, take safety precautions to prevent electrical shocks, such as wearing insulated gloves and removing the service plug grip. After removing the service plug grip, put it in your pocket to prevent other technicians from reconnecting it while you are working on the high-voltage system.

      Note

      Do not put the vehicle into the power switch on (READY) state with the service plug grip removed as this may cause a malfunction.

    2. A01NGQ8

      After disconnecting the service plug grip, wait for at least 10 minutes before touching any of the high-voltage connectors or terminals.

      Tech Tips

      At least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

  2. PRECAUTIONS FOR HYBRID CONTROL SYSTEM ACTIVATION


    1. When the warning light is illuminated or the auxiliary battery has been disconnected and reconnected, attempting to put the vehicle into the power switch on (READY) state the first time may not start the system. If so, turn the power switch off and reattempt to put the vehicle into the power switch on (READY) state.

  3. FOR USING INTELLIGENT TESTER

    CAUTION:

    Observe the following items for safety reasons:


    • Before using the intelligent tester, read the instruction manual.

    • Prevent the tester cable from being caught on the pedals, shift lever or steering wheel when driving with the tester connected to the vehicle.

    • When driving the vehicle for testing purposes using the tester, 2 persons are required. One is for driving the vehicle, and the other operates the tester.

  4. DISCONNECTING AND RECONNECTING NEGATIVE BATTERY CABLE

    A01NGJJE03
    Text in Illustration
    *1 Negative (-) Battery Terminal
    *2 Cable

    1. Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or electrical components.

    2. Before disconnecting and reconnecting the battery cable, turn the power switch off and the headlight switch off. Then loosen the terminal nut completely. Do not damage the cable or terminal.

    3. When the battery cable is disconnected, the clock and radio settings and stored DTCs are cleared. Therefore, before disconnecting the battery cable, make a note of them.

      Note


      • When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

        System Name See Procedure
        Parking Assist Monitor System

        Click here

        Side Monitor System (w/ Parking Assist Monitor System)
        Back Door Closer System
        Power Back Door System

      • w/ HDD Navigation System

        After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

        Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
        Specification Waiting Time
        w/o Telematics transceiver 60 seconds
        w/ Telematics transceiver 120 seconds