DESCRIPTION
Refer to DTC P0115 Click here.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0116 | When either of the following conditions is met (2 trip detection logic):
|
|
INSPECTION PROCEDURE
Tech Tips
If any of DTCs P0115, P0117 and P0118 are set simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
PROCEDURE
CHECK ANY OTHER DTC OUTPUT (IN ADDITION TO DTC P0116)
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | ||||||
|---|---|---|---|---|---|---|
|
Tech Tips
If any DTCs other than P0116 are output, troubleshoot those DTCs first.
| B |
|
GO TO DTC CHART Click here |
| A |
|
INSPECT THERMOSTAT
Remove the thermostat Click here.
Check the valve opening temperature of the thermostat.
| Standard |
|---|
| 80 to 84°C (176 to 183°F) |
Tech Tips
In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.
Reinstall the thermostat Click here.
| NG |
|
REPLACE THERMOSTAT Click here |
| OK |
|
REPLACE ENGINE COOLANT TEMPERATURE SENSOR Click here