STEERING WHEEL REMOVAL

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  3. REMOVE STEERING PAD

    Tech Tips

    Refer to the instructions for Removal of the steering pad Click here.

  4. REMOVE STEERING WHEEL ASSEMBLY


    1. A01NEHSE01
      Text in Illustration
      *1 Matchmark

      Remove the steering wheel assembly set nut.

    2. Put matchmarks on the steering wheel assembly and steering main shaft.

    3. Disconnect the connectors from the spiral cable.

    4. A01NEIHE01
      Text in Illustration
      *1 Turn
      *2 Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05070 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  5. REMOVE STEERING PAD SWITCH ASSEMBLY


    1. A01NCM3

      Remove the screw.

    2. Disengage the 2 claws and pin to remove the steering pad switch assembly (RH side) from the steering wheel sub-assembly.

    3. A01NGMB

      Remove the screw.

    4. Disengage the 2 claws and pin to remove the steering pad switch assembly (LH side) from the steering wheel sub-assembly.

  6. REMOVE CRUISE CONTROL MAIN SWITCH


    1. A01NEOD

      Disconnect the connector.

    2. A01NHMS

      Remove the 2 screws and the cruise control main switch.

  7. REMOVE CRUISE CONTROL SWITCH WIRE

  8. REMOVE LOWER STEERING WHEEL BOSS COVER


    1. A01NHG4

      Remove the 2 pins.

    2. Disengage the 2 claws to remove the lower steering wheel boss cover from the steering wheel sub-assembly.

  9. REMOVE STEERING PAD ATTACHING SCREW


    1. A01NG0M

      Remove the 2 steering pad attaching screws from the lower steering wheel boss cover.