POWER STEERING SYSTEM CALIBRATION


  1. ROTATION ANGLE SENSOR INITIALIZATION AND TORQUE SENSOR ZERO POINT CALIBRATION

    Note

    Clear the rotation angle sensor calibration value, initialize the rotation angle sensor, and calibrate the torque sensor zero point if any of the following has occurred:


    • The power steering ECU has been replaced.

    • The steering column assembly has been replaced.

    • Steering effort differs between turning left and right.


    1. Inspection before calibration


      1. Turn the power switch off.

      2. Connect the intelligent tester to the DLC3.

      3. Turn the power switch on (IG).

      4. Turn the intelligent tester on.

      5. Calibrate the power steering ECU. Enter the following menus: Chassis / EMPS / Data List.

      6. Check the values by referring to the table below.

        EMPS
        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        IG Power Supply

        ECU power source voltage/

        Min.: 0 V

        Max.: 20.1531 V

        		 10 to 14 V Power switch on (IG)

        Note

        If the IG power supply voltage is 9 V or less, calibration cannot be performed. In this case, charge or replace the battery, and then perform calibration.

      7. Rotation angle sensor calibration value clear, rotation angle sensor initialization, and torque sensor zero point calibration

        Note


        • If DTC C1516 (Torque Sensor Zero Point Adjustment Incomplete) is stored, the torque sensor zero point cannot be calibrated. Clear the DTC before starting calibration.

        • If DTC C1526 (Rotation Angle Sensor Initialization Incomplete) is stored, the rotation angle sensor cannot be initialized. Clear the DTC before starting initialization.


        1. Turn the power switch off.

        2. Connect the intelligent tester to the DLC3.

        3. Turn the power switch on (IG).

        4. Turn the intelligent tester on.

        5. Enter the following menus: Chassis / EMPS / Utility / Torque Sensor Adjustment.

          Note


          • Center the steering wheel and align the front wheels straight ahead.

          • Do not turn the steering wheel sharply.

          • Do not touch the steering wheel during the torque sensor zero point calibration. (Wait for 3 seconds after the calibration.)