PARKING BRAKE ASSEMBLY INSPECTION


  1. INSPECT BRAKE DISC INSIDE DIAMETER


    1. A01NDXW

      Using a brake drum gauge or an equivalent tool, measure the inside diameter of the disc.

      Standard inside diameter
      210 mm (8.27 in.)
      Maximum inside diameter
      211 mm (8.31 in.)

      If the inside diameter is more than the maximum, replace the rear disc.

  2. INSPECT PARKING BRAKE SHOE LINING THICKNESS


    1. A01NDWR

      Using a ruler, measure the thickness of the parking brake shoe lining.

      Standard thickness
      3.8 mm (0.152 in.)
      Minimum thickness
      1.0 mm (0.0394 in.)

      If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the parking brake shoe assembly.

      Note

      Always replace both right and left parking brake shoes together.

  3. INSPECT BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT


    1. A01NGV5

      Apply chalk to the inside surface of the disc, then grind down the brake shoe lining to fit the disc.

      If the contact between the disc and the brake shoe lining is incorrect, repair the brake shoe lining using a grinder or replace the parking brake shoe assembly.

      Note

      Always replace both right and left parking brake shoes together.