BRAKE MASTER CYLINDER (for LHD) DISASSEMBLY


  1. REMOVE BRAKE STROKE SIMULATOR TUBE


    1. A01ND0U

      Using a union nut wrench, disconnect the 2 union nuts to remove the brake stroke simulator tube.

  2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY


    1. A01NEMT

      Remove the 2 nuts and brake master cylinder sub-assembly from the brake master cylinder bracket.

    2. Remove the brake master cylinder gasket from the brake master cylinder sub-assembly.

  3. REMOVE BRAKE MASTER CYLINDER BRACKET


    1. Remove the brake master cylinder bracket from the brake stroke simulator cylinder with bracket.

    2. Remove the brake master cylinder gasket from the brake master cylinder bracket.

  4. REMOVE BRAKE STROKE SIMULATOR CYLINDER SUB-ASSEMBLY


    1. A01NCPI

      Disengage the clamp to separate the connector.

    2. Remove the 2 bolts and brake stroke simulator cylinder sub-assembly from the brake stroke simulator bracket.

  5. REMOVE MASTER CYLINDER PUSH ROD CLEVIS


    1. A01NETR

      Loosen the lock nut, and remove the master cylinder push rod clevis and lock nut.

      Tech Tips

      If the protrusion of the push rod in relation to the push rod clevis is measured beforehand, it is easier to perform the brake pedal height adjustment after the brake master cylinder sub-assembly is installed.

  6. REMOVE BRAKE MASTER CYLINDER UNION


    1. A01NHRT

      Remove the screw and brake master cylinder union.

  7. REMOVE MASTER CYLINDER RESERVOIR GROMMET


    1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder union.